I decided to to make a flower pot shaped like a popcorn box. To start this project off I used matte board to cut accurate measurements so all sides would be the same length. I cut a 4in by 4in square for the bottom and for the sides I cut a trapezoid with a base length of 4in, a diagonal length of 8in, and 6in for the top.
I cut the edges with a 45 degree angle to make the edges fit together better. I then slipped and scored the edges to make sure they stuck together.
I then carved lines to look more like the popcorn box. This way when I try to glaze straight lines it will be easier.
Afterwards, I carved the word popcorn into the circle just like the old fashion boxes.
I then glazed the stripes red and white. This was very difficult since the glaze would drip into the cracks making the lines look very uneven. To fix this, I took an exacto knife and scraped off the glaze where it did not belong.
I then glazed the inside red to finish the project.